Jumper Settings; Clear Cmos; Mini Pcie/Msata Signal Select - DFI CS331-C246 User Manual

CS331-C246/Q370

► Jumper Settings

Clear CMOS

I C
If any anomaly of the followings is encountered —
a) CMOS data is corrupted;
b) you forgot the supervisor or user password;
c) failure to start the system due to BIOS mis-configuration
— it is suggested that the system be reconfigured with default values stored in the ROM BIOS.
To load the default values stored in the ROM BIOS, please follow the steps below.
1. Power-off the system and unplug the power cord.
2. Put a jumper cap on JP9's pin 2 and pin 3. Wait for a few seconds and set JP9 back to
its default setting, i.e. jumper cap on pin 1 and pin 2.
3. Plug the power cord and power-on the system.
Chapter 2 - Hardware Installation
1 2 3
1-2 On:
Normal (default)
1 2 3
JP5
2-3 On:
Clear CMOS
15
► Jumper Settings

Mini PCIe/mSATA Signal Select

I C
JP9 is used to select the Mini PCIe (full-size) signal: Mini PCIe (default) or mSATA.
www.dfi.com
1 2 3
1-2 On:
Mini PCIe
(default)
JP9
1 2 3
2-3 On:
mSATA