Table of Contents
Advertisement
CS331-C246/Q370
► CPU
Installing the CPU
1. Make sure the PC and all other peripheral devices connected to it have been powered
down.
2. Disconnect all power cords and cables.
3. Locate the LGA 1151 CPU
socket on the system board.
Important:
The CPU socket must not come in contact with anything other than the CPU. Avoid
unnecessary exposure. Remove the protective cap only when you are about to in-
stall the CPU.
4. Unlock the socket by pressing
the load lever down, moving
it sideways until to escape the
retention tab. Lift the load lever
up when it's released.
Chapter 2 - Hardware Installation
► CPU
5. Lift the load lever and the load
I C
6. Remove the protective cap from
7-1.Insert the CPU into
Load lever
Retention tab
12
► Installing the CPU
Load lever
plate all the way up as shown in
the photo.
Load
plate
the CPU socket. The cap is used
to protect the CPU socket against
dust and harmful particles. Re-
move the protective cap only
when you are about to install the
CPU.
the socket. The gold
triangular mark on the
CPU must align with
the chamfer corner of
the CPU socket shown
in the photo.
www.dfi.com
Protective cap
Golden triangular
mark
Advertisement
Table of Contents
