Cpu - DFI CS331-C246 User Manual

CS331-C246/Q370
► System Memory ► Installing the DIMM Module
Please follow the steps below to install the memory card into the socket.
Step 1:
Press the eject tabs at both ends of the socket outward and downward to release them from the
locked position.
Step 2:
Insert the memory card into the slot while making sure the notch and the key are aligned. Press
the card down firmly with fingers while applying and maintaining even pressure on both ends.
Eject Tab
Step 3:
The tabs snap automatically to the edges of the card and lock the card in place.
Chapter 2 - Hardware Installation
DDR4 DIMM
Notch
Socket Top View
Key
Eject Tab
Socket Side View
Step 1
Step 2
Step 3

► CPU

The system board is equipped with a surface mount LGA 1151 socket. This socket is exclu-
sively designed for installing a LGA 1151 packaged Intel CPU.
Important:
1. Before you proceed, make sure (1) the LGA 1151 socket comes with a protec-
tive cap, (2) the cap is not damaged and (3) the socket's contact pins are not
bent. If the cap is missing or the cap and/or contact pins are damaged, contact
your dealer immediately.
2. Make sure to keep the protective cap. RMA requests will be accepted and pro-
cessed only if the LGA 1151 socket comes with the protective cap.
Note:
The system board used in the following illustrations may not resemble the actual
board. These illustrations are for reference only.
11
www.dfi.com
Step 1
Protective
cap
Step 2
Step 3