Lan Led Connector; S/Pdif Connector - DFI CS331-C246 User Manual

CS331-C246/Q370
► Internal I/O Ports

LAN LED Connector

I C
The LAN LED connector is used to detect the connection state of RJ45 LAN ports when the
connection is made to an active network via a cable. The pin functions of the LAN LED con-
nector are listed below.
▼ LAN LED Pin Assignment
Pin Assignment
1
GBE_1000
3 GBE_LED_LINK_ACT
5 LINK_1000
7 LINK_ACTIVITY
Chapter 2 - Hardware Installation
▼ LAN LED Connector
1 2
8
7
Pin Assignment
2
GBE_100
4 3V3DU
6 LINK_100
8 3V3DU
► Internal I/O Ports

S/PDIF Connector

SPDIF out
GND
SPDIF in +5V
S/PDIF
1
5
The S/PDIF connector is used to connect an external S/PDIF port. Your S/PDIF port may be
mounted on a card-edge bracket. Install the card-edge bracket to an available slot at the rear
of the system chassis then connect the audio cable to the S/PDIF connector. Make sure pin 1
of the audio cable is aligned with pin 1 of the S/PDIF connector.
27
www.dfi.com
I C