Lan Led Connector; S/Pdif Connector - DFI CS330 User Manual

LAN LED Connector

The LAN LED connector is used to detect the connection state of RJ45 LAN ports when the
connection is made to an active network via a cable. The pin functions of the LAN LED con-
nector are listed below.
Pin Pin Assignment
1 GBE_LED_1000-
3
GBE_LED_LINK_ACT-
LINK_1000_4
5
7 LINK_ACTIVITY_4
Chapter 2 Hardware Installation
Chapter 2
1 2
LAN LED
7 8
Pin Pin Assignment
GBE_LED_100-
2
3V3DU
4
LINK_100_4
6
3V3DU
8

S/PDIF Connector

1
5
+5V
SPDIF in
Ground
S/PDIF
SPDIF out
The S/PDIF connector is used to connect an external S/PDIF port. Your S/PDIF port may be
mounted on a card-edge bracket. Install the card-edge bracket to an available slot at the rear
of the system chassis then connect the audio cable to the S/PDIF connector. Make sure pin 1
of the audio cable is aligned with pin 1 of the S/PDIF connector.
26
www.dfi.com