Operation Mode Setting Switch (Mode); Maintenance Switch (Maint) - Toshiba nv Series Instruction Manual

3.1.2 Operation mode setting switch (MODE)

Figure 3-2 shows the configuration of the operation mode setting switch. Table
3-2 shows the setting details.
Figure 3-2
Table 3-2
Switch name
1
2
3
4
Note
 The loop address setting switch and operation mode setting switch in the front of the
module capture values when the power is turned on.
changed, turn on the power again.

3.1.3 Maintenance switch (MAINT)

Figure 3-3 shows the configuration of the maintenance switch.
Mentenance switch is used only when the module is inserted or removed online.
Insertion or removal is performed when the switch is set to the up (MAINT)
position to separate the module from the system.
When insertion is complete, the switch is returned to the down (RUN) position
for normal operation.
Note
 When insertion or removal is performed online while the maintenance switch is at the RUN
position, data that is different from the input may be detected.
Important
 To avoid wrong operation in a normal state, use a precision screwdriver to operate the
maintenance switch that is behind the front panel.
Operation mode setting switch configuration
Operation mode setting switch setting details
Setting description
For maintenance
For maintenance
Spare
Spare
MAINT
RUN
Figure 3-3 Maintenance switch configuration
Unified Controller nv series type2 SOE Function Instruction Manual
3.1 Switch Setting of the SA9A1
Remark
All switches are OFF when normal.
They are factory-set to OFF.
When the switch setting is
23