Operation Mode Setting Switches (Mode) - Toshiba V Series Operation Manual

Chapter 3 Setting
3.1.3

Operation mode setting switches (MODE)

3
16
The product has in it the 8-bit DIP switches that determine EN6 module operation. Use a
small screwdriver for their setting.
Each of these switches is described in Table 3-2.
Table 3-2 Operation Mode Setting Table (EN611, EN621, EN631, EN641)
Switch No. Name Function
1 M0 Operation mode
2 M1
3 SL RS-232C function
selection
4 GW Relay function (future)
5 S0 Spare 0
6 IPF IP address restriction
(Note)
7 IP0 IP address type
8 IP1
Note: This mode is valid for EN611 and EN631 only. (Not applicable to EN621 and
EN641 dual systems. If this mode is used, it is valid for line A only, provided that
a single socket interface is employed.)
Setting
M1 M0 Operation
off off Normal
off on Reserve
on off Download
on on Test program
on : Debugger, off : Tool
on : Provided, off : None
Unused
on : Free, off : Restricted
IP1 IP0 Operation
off off Class B (General)
off on Reserve
on off TOSDIC-CIE 1200
on on Set from tool
model 2000 Ethernet Module Operation Manual
Default
(Before
shipment)
M1=off
M0=off
(Normal setting)
off
off
off
off
IP1=off
IP0=off
(Class B
setting)