Settings; Introduction To Parameter Codes; List Of Parameters; Control Unit Settings - DeDietrich AMC Pro 45 Service Manual

8 Settings

8 Settings
8.1

Introduction to parameter codes

Fig.47 Code on a Diematic Evolution
00:12 ...... ........ ....... ......
....................
..... ... ....... .... .. ..... ....
....... .... .. ..... ....
....... ........... CP010
..... ... ....... ....
..... ... ....... ....
..... ... ....... .... .. ..... ....... .... ..... .......
........ .......
Fig.48 First letter
Fig.49 Second letter
Fig.50 Number
8.2

List of parameters

Tab.59 Navigation for basic installer level
Level Menu cascade
Basic installer
(1) See the column "Submenu" in the following table for the correct navigation. The parameters are grouped in specific functionalities.
Tab.60 Factory settings at basic installer level
Code Display text
AP016 CH function
on
AP017 DHW function
on
56 AMC Pro
.........
.......
...
......
.....
CP010
AD-3001373-02
CP010
AD-3001375-01
CP010
AD-3001376-01
CP010
AD-3001377-01
> Installation Setup > CU-GH08 > Submenu
Description
Enable central heating heat
demand processing
Enable domestic hot water
heat demand processing
The controls platform makes use of an advanced system to categorise
parameters, measurements and counters. Knowing the logic behind these
codes, makes it easier to identify them. The code consists of two letters
and three numbers.
The first letter is the category the code relates to.
A Appliance: Appliance
C Circuit: Zone
D Domestic hot water: Domestic hot water
G Gas fired: Gas-fired heat engine
P Producer: Central heating
Category D codes are appliance controlled only. When the domestic hot
water is controlled by an SCB, it is handled like a circuit, with C-category
codes.
The second letter is the type.
P Parameter: Parameters
C Counter: Counters
M Measurement: Signals
The number is always three digits. In certain cases, the last of the three
digits relates to a zone.
8.2.1

Control unit settings

Important
All tables show the factory setting for the parameters.
The tables also list parameters that are only applicable if the
boiler is combined with other equipment such as an outdoor
sensor.
All possible options are indicated in the adjustment range. The
display of the boiler only shows the relevant settings for the
appliance.
> Parameters, counters, signals > Parameters
(1)
Range
0 = Off
1 = On
0 = Off
1 = On
Submenu 45 65
Gas fired 1 1
appliance
Gas fired 1 1
appliance
7725087 - v.01 - 06062019
90 115
1 1
1 1