Firmware Update/Changing The Display Language - GRAUPNER mc-28 Manual

Firmware update/Changing the display language

 HIDDEN MODE 
VOICE
FIRMWARE UPDATE
STICK CALI.
BLUETOOTH INIT.
FILE LIST
MC-28_1V234_Dutch.bi
MC-28_1V234_France.
MC-28 1V234 German.b
MC-28_1V234_English.
MC-28_1V234_Italiano
MC-28_1V234_Spain.bi
Firmware Download

Prozess Start

Please Wait....

Stick calibration
HIDDEN MODE 
VOICE
FIRMWARE UPDATE
STICK CALI.
BLUETOOTH INIT.
1 0% 2 0%
3 0% 4 0%
5 0% 6 0%
7 0%
8 0%
9 0% 10 0%
11 0% 12 0%
13 0% 14 0%
15 0% 0%
16
33028_mc28_T1V3_sh_en
Note
• Before each update, check the transmitter battery charge or
charge it as a precaution, and save all model memories so that
they can be restored if necessary.
• Follow the "Firmware update step by step" manual steps from
the section "Firmware update" "Update per memory card".
Firmware update step by step
Move with a short pressure on the SET key to the selection page of
the option "FIRMWARE UPDATE".
Select the firmware version with the selection keys.
Confirm by pushing the SET key.
The storing in the transmitter memory will start:
Firmware
 
Downloading...
 
Progress
 
When the counter reaches the storing amount the storage process is
finished and the message "Firmware upgrade success!" appears.
If you feel that the middle and end positions of the self-neutralizing
sticks and / or the proportional sliders do not exactly correspond to
0 or 100% encoder travel, then you can check and correct this your-
self.
Stick calibration step by step
1. In the "Model Selection" menu, initialize a free model memory
with a model type with four control functions.
2. Assign both the center and side proportional sliders to a free con-
trol channel in the »Transmitter Setting« menu. Preferably, the
channels 5 ... 8.
3. If necessary assign existing rotary controls to further control
channels.
4. Do not carry out any further programming and do not adjust the
trims.
5. By simultaneously pressing the
button, call up the »Servo display«.
6. Move each stick and each of the four proportional slides one by
one to the center position and to each stop position, and check
that the% values correspond to the set points of 0, -100% or
+100%.
7. ...
... result in these values, there is no further need for action and
the just initialized model memory can be deleted as a result.
Firmware
 
Downloading...
 
023/208 Progress
 
buttons on the left four-way


023/208

31 / 40