Interfaces - GRAUPNER mc-28 Manual

Interfaces

Provided connection
2
3
1
1 2
USB connected

PC COM Port
Mass storage
Charge only
14 / 40
Left provided connections
1. DSC socket
On the left side is located the DSC socket. This socket allows the
trainer/pupil function and the use of flight simulators.
For more information on the DSC socket and the trainer/pupil
function see the section "DSC socket".
2. SD card slot
The card slot is suitable for micro SD memory card. For informa-
tion on removing and inserting the memory card, refer to the
section "memory cards".
3. Ear phones port
The ear phones port is suitable for a 3,5 mm jack. Though this
interface both acoustic signals and voice messages are emitted.
The volume can be controlled by "Voice volume" and "Signal vol-
ume" in the general settings.
Right provided connection
1. Micro USB port / battery charge and PC connection
Note
The micro USB socket is not suitable for flight simula-
tor connection.
As soon as you connect the USB cable to the transmitter a selec-
tion menu appears. Here you can set up the function of the micro
USB port.
PC COM Port - for updates
Mass storage memory - to access to the SD card
Battery charge - only battery charging
Battery charging
Through the micro USB port you can charge the transmitter bat-
tery. Use the included USB cable to connect the transmitter to a
suitable USB port and charge the transmitter battery. If the trans-
mitter is switched on the charge time is longer than if the trans-
mitter is switched off.
The maximum charge current is 2 A.
More information are available in the section "Charging the
transmitter battery".
33028_mc28_T1V3_sh_en