Firmware Update; So Are Update Using Computer - GRAUPNER mz-16 HoTT Manual

Firmware Update

So ware Update Using Computer
Firmware updates for the transmi er can be done wireless over a WiFI
network or via the back of the radio using the micro USB port. When the
transmi er is connected to a PC the USB menu is automa cally shown.
For rmware update select the "Mass Storage" op on by tapping on the
Mass Storage icon.
When the "Mass Storage" op on is selected your PC will recognize the
transmi er as a disk drive.
All required programs and es needed to update your Graupner products
can be found both in the directory "U
transmi er.
Copy the so are package labeled grstudio_x.x.x.x+setup.exe from the
transmi er's mass storage drive to your computer. When using Windows
e explorer look for the "MZ-16 (X:) drive.
You can also download the latest so
www.graupner.com
please note that the so
Follow the installa on procedures for the grstudio so
install new Virtual COM Port drivers to access the radio.
A er successful comple on of the so
to update your so are:
1. Connect the mz-16 HoTT transmi er to a Windows PC or laptop via
the rear micro-USB port.
2. Switch on the transmi er.
3. Select "Mass storage" in the automa cally displayed selec on
display.
4. Start the program "grstudio_x.x.x.x_exe" on your computer.
5. In the sec on "Transmitter" of the grstudio select the mz-16 Radio
Downloader op on.
6. You will have the op on to only download the rmware or also
resources such as voice les, help es and other so
In case important resources
check the select download incl. resource op on. At one point you will
have the op on to select the languages available. Select your
preferred languages only as this will decrease the download me.
Page 43 of 48
on the mass memory of the
are from our website at
are only works on Windows computers.
are installa on follow the nest steps
update are available you should
are which will also
are updates.
S1047.mz-16-V1.0-EN