Opening/Closing The Transmitter Housing - GRAUPNER mc-28 Manual

Opening/closing the transmitter housing

33028_mc28_T1V3_sh_en
The transmitter should be opened only in the following cases:
• If a self centering stick has to be converted in non self centering
• If a non self centering stick has to be converted in self centering
• To set the control stick centering force
Open step by step
Before opening the housing switch the transmitter off.
Open the battery case.
Remove the battery.
If the hand rests are installed: Loosen each of the three lower screws
of the six fixing screws securing the hand pads.
Loosen the five case screws.
Hold both housing halves with both hands and let the screws fall on
a proper surface turning the transmitter upside-down.
Rotate the lower case and lay it on one side.
Attention
Never switch the transmitter on while the housing is open! Do not
touch the electronic boards.
Closing step by step
Check if the upper and the lower part of the transmitter housing are
correctly coupled.
Screw the housing screws in their original position.
Connect the battery.
Install the hand pads again.
21 / 40