Commissioning; Hand Pads; Brackets For Transmitter Belt; Anchorage For The Transmitter Belt - GRAUPNER mc-28 Manual

Commissioning

Hand pads

Installing the hand pads
Removing the hand pads

Brackets for transmitter belt

Anchorage for the transmitter belt

20 / 40
The hand pads have to be installed on the sides of the transmitter.
Hold the hand pad exactly upon the six holes and fix it with the 6 fix-
ing screws. Use the same procedure for the other hand pad.
Attention
Screw the fixing screws only with the hand pads on the transmitter
case. The place inside the transmitter case will otherwise not be
enough and you could damage the boards.
The hand pads are removed by unscrewing the fixing screws.
After removing the screws glue the included rubber pins on the
holes. So you will protect the transmitter interior.
Attention
Do not screw the fixing screws in the holes after removing the hand
pads! The place inside the transmitter case will not be enough and
you could damage the boards.
Installing the metal brackets
Insert the included metal bracket in the bracket holder on the side
of the transmitter.
Push the bracket against the spring (approx. 1 cm in the transmitter
direction).
Contemporaneously rotate the bracket to the outside to fix it.
Proceed similarly with the second bracket.
Removing the metal brackets
Unlock a bracket, by gently pushing it inwards and then fold in the
direction of the transmitter center.
Once the retaining pin is free again, you can pull the bracket away
from its place.
Proceed similarly with the second bracket.
On the upper side of the transmitter there is an eyelet which can be
used to hook a neck-strap.
33028_mc28_T1V3_sh_en