Firmware Update; Transmitter Software Update - GRAUPNER mz-10 HoTT S1001 User Manual

Hide thumbs Also See for mz-10 HoTT S1001:
Table of Contents

Advertisement

Firmware update

Transmitter software update

S1001_jp_V1
The programs and files which are also required for updating the
transmitter combined into one software package can be down-
loaded from www.graupner.de.
Download this software package from the Internet, and unpack
it on your computer. All other information can be found in inter-
net in the same page where the software package is available.
Transmitter firmware updates can be performed through the
three pole PC interface (DATA socket) on the back side of the
transmitter.
Suggested accessories
For an update of the transmitter software you need the available
accessory USB interface so as the adapter cable.
Notes
Please note that compatible firmware is required for reliable

communication between the HoTT components. The programs
and files that are required to update are therefore combined into
a single file.
The current firmware packet version can be found on the Internet

at www.graupner.de.
Only operate your transmitter using the current software version.

These information can also be found at: www.graupner.de =>
Service & Support => Update and revision history for GRAUPNER
HoTT components.
Before each update check the transmitter battery charge status.

Do not disconnect the link to the computer during an update!

Make sure that the link between the transmitter and computer is
operational.
After each update, check if the model functions are correct.

You can find accessories on www.graupner.de.
Perform update step by step:
• Connect the interface through the included USB cable to a
PC.
• If you have already installed the required drivers for the inter-
face, the red LED on the interface board will light on.
• Switch off the transmitter. Connect the switched off transmit-
ter to the USB interface board through the adapter cable.
You can perform a firmware update by the "Firmware_
Upgrade_gr_Studio" program in the program group "devices"
with the sub-program "HoTT devices".
37 / 40

Advertisement

Table of Contents
loading

Table of Contents