HPC CodeMax Manual page 32

4. P ress "A" to change to the Contour Cutting Mode. Contour Cutting will
remove peaks between cuts on a key, for smoother operating automotive keys (only
recommended for automotive keys). Press "A" again to return to the Standard
Cutting Mode.
5. P ress "6" to decrease the rate of speed at which the pivot arm approaches
the cutter or press "8" to increase the rate of speed at which the pivot arm
approaches the cutter. This is particularly useful when dealing with hardened
keys and wanting to cut them at a slower rate.
Fewer bars = slower
6. In the case of "Double-Sided Different" keys, after cutting the first side, press ENTER
to autoload the next DSD Number associated with the manufacturer chosen.
If cutting a single-sided key or if the second side is the same as the first, pressing
ENTER will return to the Main Screen.
CONTOUR
Switch Contour cutting on and off.
CUT SPEED
More bars = faster
CodeMax
®
31