Carburetor Heat And Air Filter Installation - Cessna T182 Series Service Manual

MODEL 182 & T182 SERIES SERVICE MANUAL
The magneto is in a SWITCH ON condition
It is a good practice to position No. 1
when the switch wire is disconnected.
cylinder at its approximate advanced
Therefore. ground the breaker contact
firing position before removing the
points or disconnect the high-tension wires
magneto.
from magneto to spark plugs.
c.
Remove nuts, washers and clamps attaching the
a.
Remove engine cowling in accordance with para-
magneto to the engine accessory housing.
Note the
graph 11-3.
approximate angular position at which the magneto is
b.
Remove the eight screws securing the high-
installed, then remove the magneto.
tension outlet cover to the magneto.
The "P"
d.
Reverse the preceding steps for reinstallation
leads may be disconnected for additional clearance
and time magneto-to-engine in accordance with para-
if necessary.
graph 11A-62.
1. Air Filter Box
2. Air Filter Assembly
NOTE
3. Air Box Inlet Clamp
4. Air Box
If the aircraft is equipped with a modified
5. Carburetor Heat Selector Valve Arm
carburetor heat shroud (8), refer to Ser-
6. Clamp
vice Kit #SK182-78 for installation instruct-
7. Carburetor Heat Inlet Duct
ions.
8. Carburetor Heat Shroud
9. Upper Shroud Clamp
Not used with modified heat shroud.
10. Lower Shroud Clamp
Figure 11A-4. Carburetor Heat and Air Filter Installation
11A-15