Table of Contents
Advertisement
MODEL 182 & T182 SERIES SERVICE MANUAL
2. Bearing End Assembly
7. Rudder Bar Arm
3.
Steering Bungee Assembly
8.
Pivot Bolt
Figure 5-14. Nose Wheel Steering System (Model 182)
5-70. REMOVAL.
(Model T182 thru 18268055.)
a. Install steering bungee assembly (9) such that
(See figure 5-15. )
shaft is positioned between ears of rudder bar assem-
a. Disconnect bearing end assembly (3) from steer-
bly (7).
ing bellcrank (2) on nose gear strut.
b. Install barrel nut (11) and two snap rings (12).
b. Disconnect rod end assembly (6) from rudder
c.
Connect bearing end assembly (3) to steering
bar assembly (7).
bellcrank (2) on nose gear strut.
c. Remove sprocket (8) from chain assembly; re-
d.
Install flex shaft (13) over shaft of steering bun-
move steering bungee assembly (9).
gee assembly (9); install pin (14).
5-71. INSTALLATION.
(Model T182 thru 18268055.)
REMOVAL AND INSTALLATION OF NOSE
(See figure
5-15.
)
WHEEL STEERING SYSTEM COMPONENTS.
(See
Install chain assembly on sprocket (8).
)figures
5-14 and 5-15. ) Use the applicable figure
a. Install chain assembly on sprocket (8).
as a guide in determining system component
b. Connect rod end assembly
(6)on rudder bar
as a guide in determining system component
b. Connect rod end assembly (6) to rudder bar
relationship and for removal and installation of sys-
assembly (7).
ter
components.
c.
Connect bearing end assembly (3) to steering
bellcrank (2) on nose gear strut.
5-75. RIGGING OF NOSE WHEEL STEERING SYS-
TEM.
Since the nose wheel steering system is
5-72. REMOVAL.
(Model T182 beginning with
directly connected to the rudder control system, ad-
18268056. ) (See figure 5-15. )
justment to one system would directly affect the other.
a. Disconnect bearing end assembly (3) from steer-
Refer to Section 10 of this manual for rigging pro-
ing bellcrank (2) on nose gear strut.
cedures for the rudder control system and the nose
b. Remove pin (14) and flex shaft (13) from shaft of
wheel steering system.
steering bungee assembly (9).
c.
Remove snap rings (12) and barrel nut (11),
5-76.
BRAKE SYSTEM.
securing steering bungee assembly (9) to ears of
rudder bar assembly (7).
5-77. DESCRIPTION.
The hydraulic brake system
d. Disconnect bearing end assembly (3) from steer-
is comprised of two master brake cylinders, located
ing bungee assembly (9).
immediately forward of the rudder pedals, brake lines
5-73. INSTALLATION.
(Model T182 beginning with
cylinder, and the single-disc, floating cylinder-type
18268056. ) (See figure 5-15.)
brake assembly, located at each main landing gear
wheel.
5-29
Advertisement
Table of Contents
Troubleshooting
