Troubleshooting - Landing Gear - Cessna T182 Series Service Manual

MODEL 182 & T182 SERIES SERVICE MANUAL
Page No.
Page No.
TABLE OF CONTENTS
Aerofiche/Manual TABLE OF CONTENTS
Aerofiche/Manual
Hydraulic Brake Lines
..... 1I8/5-34 Installation .........
1I9/5-35
Description .........
1I8/5-34 Brake Lining Wear
.... . 1I9/5-35
Wheel Brake Assemblies .....
1I8/5-34 Brake Lining Installation
. . . . 1I9/5-35
Description . ....... 1I8/5-34
Brake Bleeding . ... . . 1I9/5-35
Removal ......
... . 1I8/5-34 Parking Brake System
... .. 1I9/5-35
Disassembly
........ 118.5-34
Description ......... 1I9/5-35
Inspection/Repair .
... . 1I8/5-34 Removal/Installation .....
1I9/5-35
Reassembly ........
. 119/5-35 Inspection/Repair.
..... . 119 5-35
5-1. LANDING GEAR.
5-2. DESCRIPTION. These aircraft are equipped
stalled on the axle at the lower end of the strut. The
with non-retractable, tricycle landing gear, utilizing
nose gear is a combination of a conventional air/oil
tubular spring-steel main landing gear struts. A
(oleo) strut and fork, incorporating a shimmy dam-
bracket to attach a step to each strut is bonded to each
pener. The nose wheel is steerable with the rudder
strut. The main gear struts are enclosed by stream- pedals up to a maximum pedal deflection, after which
lined fairings. Wheel brake lines are routed through
it becomes free-swiveling up to a maximum travel of
the fairings to each main wheel. Brake fairings and
30 degrees right or left of center. Through use of the
main wheel speed fairings am installed on these air-
brakes, the aircraft can be pivoted about the outer
craft. Disc-type brakes and tube-type tires are in-
wing strut fitting. A speed fairing is installed on the
nose gear.
5-3. TROUBLE SHOOTING -- LANDING GEAR
TROUBLE
PROBABLE CAUSE REMEDY
AIRCRAFT LEANS TO
Incorrect tire inflation. Inflate to correct pressure.
ONE SIDE.
Loose or defective landing gear
Tighten or install new parts.
attaching parts.
Landing gear spring excessively Install new landing gear spring strut.
sprung.
Bent axle(s).
Install new axle(s).
TIRES WEAR EXCESSIVELY. Incorrect tire inflation. Inflate to correct pressure.
Wheels out of alignment.
Align wheels in accordance with
paragraph 5-29.
Landing gear spring excessively
Install new landing gear spring
sprung.
strut.
Bent axle(s). Install new axle(s).
Dragging brakes. Refer to paragraph 5-78.
Loose or defective wheel bearings. Install new bearings.
Wheels out of balance.
Correct in accordance with para-
graph 5-30.
WHEEL BOUNCE EVIDENT Out of balance condition.
Correct in accordance with para-
EVEN ON SMOOTH SURFACE.
graph 5-30.
5-2 Revision 1