Table of Contents
Advertisement
MODEL 182 & T182 SERIES SERVICE MANUAL
3-1.
FUSELAGE.
3-7. WINDOWS.
3-2. WINDSHIELD AND WINDOWS.
3-8. MOVABLE.
(See figure 3-3.)
3-3. DESCRIPTION. The windshield and windows
3-9.
DESCRIPTION. A movable window, hinged at
are single-piece, acrylic panels, set in sealing strips
the top, is installed in the left cabin door, and may
strips and held by formed retaining strips, secured to
also be installed in the right cabin door, as optional
fuselage with screws and rivets. H.B Fuller FS-4291
equipment. A rubber seal is cemented to the inside
sealant is applied to all edges of the windshield and
of the window frame, using 3M Co. EC-800 adhesive,
windows, with exception of wing root area. The
or equivalent.
wing root fairing has a heavy felt strip that com-
pletes the windshield sealing.
3-10. REMOVAL AND INSTALLATION.
a. Disconnect window stop (3).
3-4. WINDSHIELD. (See figure 3-2.)
b. Remove pins from window hinges.
c. To remove frame from plastic panel, drill out
3-5.
REMOVAL.
blind rivets at frame splice.
a. Remove magnetic compass. (See Section 16.)
d.
Reverse preceding steps for installation.
b. Remove wing
that sealing strip and an adequate coating of Presstite
If windshield is to be reinstalled, be sure to
protect windshield during removal.
d. With two people sitting in the airplane placing
3-12.
DESCRIPTION. The rear window is a one-
their feet against the windshield, just above the cen-
piece acrylic plastic panel, set in sealing strips,
terline, press upward on windshield forcing it out of
and held inplace by retaining strips.
lower retainers.
e. Clean sealer from inner sidewalls and bottom of
3-13. REMOVAL AND INSTALLATION.
retainers.
a. Remove upholstery as necessary to expose
retainer strips inside cabin.
3-6. INSTALLATION.
b. Drill out rivets as necessary to remove re-
a.
If new windshield is to be installed. remove pro-
tainers on both sides and lower edge of window.
tective cover and clean, take care not to scratch
c. Remove window by starting at aft edge, and
windshield.
pulling window into cabin area.
b.
Apply new felt to edges of windshield.
d. Reverse preceding steps for installation.
c.
Apply a strip of sealer (H.B. Fuller FS-4291)
e. When installing a new rear window, check fit
along the sides and bottom of felt.
and exercise care not to crack panel.
d.
Position bottom edge of windshield into lower
f.
File or grind away excess plastic.
retainer.
g. Install sealing strips, and apply an adequate
e.
Using a piece of bent sheet metal (8 in. wide x
coating of sealing compound, to prevent leaks.
length of top edge of windshield) placed under top
edge of upper retainer. bow windshield and guide top
3-14. OVERHEAD.
(See figure 3-2.)
edge of windshield into upper retainer using bent
sheet metal in a shoe horn effect.
3-15. DESCRIPTION. Overhead cabin windows,
f.
Install air vent tubes.
located in the cabin top, may be installed. These
g.
Install wing fairings.
windows are one-piece acrylic plastic panels, set
h.
Install magnetic compass. (See Section 16.)
in sealing strips, and held in place by retaining
strips.
3-16. REMOVAL AND INSTALLATION.
a.
Remove headliner and trim panels.
b. Drill out rivets as necessary to remove retainer
strips, remove window.
3-2
Revision 1
Advertisement
Table of Contents
Troubleshooting
