Table of Contents
Advertisement
TRANSITION Setting
Transition is used to set the switching mode between different input sources.
Push【MENU】，select<TRANSITION>，press 【OK】
Enter the menu as below
MODE：Special effects switching modes, including FADE, CUT, WIPE SOUARE IN, WIPE SOUARE OUT, WIPE TOP
LIEFT IN, WIPE TOP LIEFT OUT, WIPE TOP RIGHT IN, WIPE TOP RIGHT OUT, WIPE BOTTOM LEFT IN, WIPE
BOTTOM LEFT OUT, WIPE BOTTOM RIGHT IN, WIPE BOTTOM LEFT OUT, WIPE LEFT IN, WIPE LEFT OUT, WIPE
RIGHT IN, WIPE RIGHT OUT, WIPE TOP IN, WIPE TOP OUT, WIPE BOTTOM IN and WIPE BOTTOM OUT
DURATION:set the transition time ranging from 0 to 1S by rotating the knob and pressing 【OK】.
ALPHA:set the image transparency ranging from 0 to 1S by rotating the knob and pressing 【OK】.
DEINTERLACE:select ON or OFF to enable or shut down the deinterlacing function
IMAGE ENHANCE:image enhancement function, for image edge sharpening, color reduction and image scaling.
Select ON or keep pressing 【TAKE】button 3s to enable the function. The selected input signal will be switched
to output as the TRANSITION set.
© Xiamen RGBlink Science & Technology Co., Ltd.
Ph: +86 592 5771197 |
INPUT
OUTPUT
>TRANSITION
AUDIO
SPLIT
>MODE
DURATION
ALPHA
DEINTERLACE
IMAGE EHANCE
>TAKE
support@rgblink.com
>>
>>
>>
>>
>>
FADE
0.5S
16
ON
OFF
ON
|
www.rgblink.com
21 / 28
Advertisement
Table of Contents
