Screen Setting And【Fs】Button - RGBlink C1US Quick Start Manual

Screen Setting And【FS】Button
The setting of <SCREEN> is based on the resolution of the LED screen,applicable under single picture mode. For
example to display picture on a LED screen with resolution 1408x832, first of all, a resolution close to or bigger
than 1408x832 shall be selected. In this case, 1440x900 or resolution above will be proper choice. The closer to
the LED screen resolution, the better the display will be.
Push【MENU】,select<OUTPUT>;
Press 【OK】, select <SCREEN>，press 【OK】again or the knob.
Then enter the menu of <SCREEN>
H SIZE:turn knob or press numeral button to set the horizontal pixels of the LED screen, e.g1408；
V SIZE:turn knob or press numeral button to set the vertical pixels of the LED screen, e.g 832
H POS:initial parameter is 0, if the picture is not skew, do not set.
V POS:initial parameter is 0, if the picture is not skew, do not set.
Mode:Turn knob to select <SCREEN SIZE> or <FULL SIZE>
If operation is not proper, turn knob to <RESET> and start over.
Note： Users can also set <SCREEN> by 【 FS】 . Press 【FS】 and button light is on, Led display image in screen size,
press 【FS】again, button light goes off, Led display image in full size.
© Xiamen RGBlink Science & Technology Co., Ltd.
Ph: +86 592 5771197 |
INPUT
>OUTPUT
TRANSITION
AUDIO
SPLIT
OUTPUT INFO
OUTPUT FORMAT
OUTPUT ADJUST
>SCREEN
RATIO
H SIZE
V SIZE
H POS
V POS
MODE
support@rgblink.com
>>
>>
>>
>>
>>
>>
>>
>>
>>
NORMAL
1408
832
0
0
FULL SIZE
| www.rgblink.com
13 / 28