Ricoh SP5 Series Service Manual page 186

3,000-SHEET FINISHER (A697)
A697I511.WMF
7. Attach the cushion [A] to the plate as shown.
8. Install the entrance guide plate [B] (2 screws).
9. Open the front door of the finisher, and remove the screw [C] which secures the
locking lever [D]. Then pull the locking lever.
10. Align the finisher on the joint brackets, and lock it in place by pushing the
locking lever.
NOTE: Before securing the locking lever, make sure that the top edges of the
finisher and the copier are parallel from front to rear as shown [E].
11. Secure the locking lever (1 screw) and close the front door.
12. Attach the exit guide mylar [F] to the anti-static brush bracket located above the
upper tray exit roller as shown.
13. Install the shift tray [G] (4 screws).
14. Connect the finisher cable [H] to the main machine.
15. Attach the staple position decal [I] to the ARDF as shown.
16. Turn on the main power switch and check the finisher operation.
[E]
[A]
[B]
[F]
[H]
[G]
3-30
June 30, 1998
A229I534.WMF
[I]
[D]
[C]
A229I528.WMF