Ram300 Memory Mezzanine Installation - Motorola MCP750HA Series Installation And Use Manual

3. Carefully remove the MCP750HA from the CompactPCI card slot
Avoid touching areas of integrated circuitry; static discharge can damage
these circuits.
Caution
4. If installed, remove the RAM300 mezzanine module by first
5. Slide the Compact FLASH memory card into the J20 connector and
6. Place the RAM300 mezzanine module on top of the base board. The
7. Insert the four short phillips-head screws through the holes at the
8. Reinstall the MCP750HA assembly in the proper card slot. Ensure
9. If the board was installed in a non-hot swap chassis, replace the

RAM300 Memory Mezzanine Installation

The RAM300 DRAM mezzanine mounts on top of the MCP750HA base
board. To upgrade or install a RAM300 mezzanine, refer to
proceed as follows:
http://www.motorola.com/computer/literature
and place it on a clean and adequately protected working surface
with connectors J1 through J5 facing you.
removing four phillips-head screws at the corners of the mezzanine
and then by gently lifting it near the connector end of the module.
Refer to the RAM300 Memory Mezzanine Installation
below.
ensure that pin 1 of the card aligns with pin 1 of J20.
connector on the underside of the mezzanine should connect
smoothly with the corresponding connector (J7) on the
MCP750HA.
corners of the RAM300 mezzanine and into the standoffs on the
MCP750HA. Tighten the screws.
that the module is properly seated in the backplane connectors. Do
not damage or bend connector pins.
chassis or system cover(s), reconnect the system to the AC or DC
power source, and turn the equipment power on.
RAM300 Memory Mezzanine Installation
procedure
Figure 1-4 and
1-11
1