High Availability Commands; Unsupported Commands; Table 5-2. High Availability Specific Debugger Commands; Table 5-3. Unsupported Debugger Commands - Motorola MCP750HA Series Installation And Use Manual

High Availability Commands

The following table lists PPCBug debugger commands that have been
added to support High Availability (HA) features. These are only available
when the MCP750HA is used in a system with the appropriate Motorola
Hot Swap Controller.

Table 5-2. High Availability Specific Debugger Commands

Name
PEEPROM
PCIDOM
PWROFF
PWRON
PCIIOI
You can list the syntax for one of these commands using the HE command
with the command name. For example,
HE PWROFF <Return>
shows the syntax for using the
For additional information about the High Availability commands, refer to
the CPX750 High Availability PPCBug Firmware User's Manual, listed in
Appendix C, Related

Unsupported Commands

The following table lists standard PPCBug debugger commands that are
not supported on the MCP750HA

Table 5-3. Unsupported Debugger Commands

Name
DMA
FORK
FORKWR
IDLE
IRD
http://www.motorola.com/computer/literature
Description
Program/Verify the HSC EEPROM
Initialize/Control PCI Bus Domain
Power Off an HA PCI Bus Module
Power On a HA PCI Bus Module
PCI Domain I/O Inquiry
command to power an I/O module.
PWROFF
Documentation.
Description
DMA Block of Memory Move
Fork Idle MPU at Address
Fork Idle MPU with Registers
Idle Master MPU
Idle MPU Register Display
Using PPCBug
5
5-11