Introduction; Sdr (Sensor Data Record) Device Commands; Appendix E Related Documentation - Motorola CPIP5430 Installation And Use Manual

Introduction

For other supported IPMI commands (listed below) refer to the MXP IPMI
Subsystem Reference Manual and the IPMI 1.0 specification for a
complete description of these commands. These documents are listed in
Appendix E, Related
The following IPMI commands are implemented in this release of the
CPIP5430. These commands may be used by a host device driver and/or
application software to communicate with the Zircon, sensors, and other
management controllers in the system.

SDR (Sensor Data Record) Device Commands

Zircon firmware supports only the repository updates. During SDR update
only (also called modal mode) the commands listed below are supported.
Commands not supported during update mode will be responded to with a
completion code of SDR Repository Update in progress.
ENTER SDR REPOSITORY UPDATE MODE
EXIT SDR REPOSITORY UPDATE MODE
DIPMI Commands
Documentation.
IPM Device Global Commands
PMC Watchdog Timer Commands
Event Commands
Chassis Commands
SEL Device Commands
FRU Inventory Commands
Used to enter SDR Repository Update Mode.
Used to exit the SDR Repository Update Mode.
D
D-1