EMC Connectrix EC-1100 System User Manual page 20

Warnings and Cautions
Additional Warnings
and Cautions
Static Precautions
xx Connectrix EC-1100 System User Guide
Before attempting to service a Connectrix unit, observe the following
additional Warnings and Cautions:
WARNING
The Connectrix contains no user-serviceable parts, so it should not be
moved or opened for any reason by untrained persons. If the
Connectrix needs to be relocated or repaired, only qualified personnel
familiar with safety procedures for electrical equipment and the
Connectrix hardware should access components inside the unit or
move the unit.
WARNING
The system operates at high voltages. To protect against physical
harm, power off the system whenever possible while servicing.
WARNING
In case of fire or other emergency, isolate the system's power
involved and alert appropriate personnel.
CAUTION
!
Trained personnel are advised to exercise great care at all times
when working on the Connectrix unit. Remember to:
• Remove rings, watches, or other jewelry and neckties before
you begin any procedures.
• Use caution near any moving part and any part that may start
unexpectedly such as fans, motors, solenoids, etc.
• Always use the correct tools for the job.
• Always use the correct replacement parts.
• Keep all paperwork, including incident reports, up to date,
complete, and accurate.
EMC incorporates state-of-the-art technology in its designs, including
the use of LSI and VLSI components. These chips are very susceptible
to damage caused by static discharge and need to be handled
accordingly.