EMC Connectrix EC-1100 System User Manual page 108

Fabric Zoning
4
Other Zoning Tasks
Viewing, Copying,
Deleting, or Modifying
Connectrix EC-1100 System User Guide
4-16
You can view zone members, as well as copy, delete, or modify zones
through the Actions pop-up menu in the New Zone Set or Modify
Zones
Zone Set dialog box. The following steps use the New Zone Set
dialog box for examples.
1. From either the Zoning View or Topology View, move your
cursor over the Configure icon and click Zone Sets on the pop-up
menu.
This displays the Zone Sets dialog box (shown in Figure 4-7 on
page 4-13).
2. Click a zone set in the Zone Set Library section of the dialog box,
then move your cursor over the Actions icon and click New on
the pop-up menu.
This displays the New Zone Set dialog box (shown in Figure 4-8
on page 4-14).
3. Click the desired zone, then move your cursor over the Actions
icon and click the appropriate action:
• Modify Zone
• Delete Zone
• View Zone Members
• Copy Zone
Follow the action-specific steps described below.
To view zone members:
Clicking View Zone Members on the Actions menu on the New
Zone Set dialog box displays a list of members.
To copy a zone:
Clicking Copy Zone on the Actions menu on the New Zone Set
dialog box displays a Copy Zone dialog box. Enter a zone name in
the Copy to: field and click OK. This creates a new zone containing
the same members in the zone that you selected in the Zone Library.
To delete a zone:
Clicking Delete Zone on the Actions menu on the New Zone Set
dialog box displays a dialog box asking you to confirm the deletion.
Click Yes. The zone is removed from the Zone Library and all zone
sets.