EMC Connectrix EC-1100 System User Manual page 110

Fabric Zoning
4
Connectrix EC-1100 System User Guide
4-18
2. Enable or disable the Show unused ports check box:
• A check mark enables all ports on all directors to be displayed
in the Attached ports/nodes section of the dialog box. If you
chose Add by port number in step 1, you must enable this
box.
• An empty check box enables only those ports with attached
nodes to be displayed.
3. Display ports in the Attached ports/nodes section by clicking on
the magnifying glass icon by a numbered domain. The list of
ports expands under the domain.
The magnifying glass icon will not appear by a domain if the Add by
World Wide Name radio button is selected and there are no nodes
attached to ports on a director or if the Add by port number radio button
is selected, the Show unused ports check box is deselected, and there are
no nodes attached to director ports.
4. Add members to the zone using one of the following procedures:
• Select and drag members (ports and/or node WWNs) from
the Attached ports/nodes section to the Members in Zone
section of the dialog box.
Figure 4-11 illustrates both ports (prefixed with the domain
number) and node WWNs in the Members in zone section.
Selecting and dragging ports from the Attached ports/nodes
section to the Members in zone section with the Add by
World Wide Name radio button selected places the device
WWN into the Members in zone section as shown.