Table of Contents
Advertisement
Structure and function
2.3.3
Replacement parts
The replacement parts include:
•
Milling cutter (can be ordered individually)
•
Replacement spacer plate for the clamping V-block (can be ordered individually)
•
Release agent tank (1 litre silicone-free weld spatter release agent)
2.3.3.1
Replacing milling cutter
1.
Remove protective cover (1).
2.
On the milling cutter detach threaded pin M
5x6 and pull off milling cutter.
3.
Put on new milling cutter and tighten with
threaded pin M 5x6.
4.
Re-attach the protective cover (1) after
replacing the milling cutter.
2.3.3.2
Replacing spacer plate
1.
The clamping V-block is screwed on with 2
cheese-head screws and pegged. Detach
screws (1) and pins (2).
2.
Take off clamping V-block (3) and spacer
plate (4).
3.
Select new spacer plate (see
screw back on clamping V-block and peg.
2-10
At the factory the motor shaft is drilled approx. 1 mm
deep through the core hole in assembly of the first mill-
ing cutter in order to safely rule out axial migration of
the milling cutter.
Table
The center misalignment of the torch nozzle must then
be corrected in the robot program.
3HDA000057A8519-001
NOTICE
3
2-1) and
4
NOTICE
1
2
1
Torch cleaner TC 2013
Advertisement
Table of Contents
