Table of Contents
Advertisement
Technical data of TC 2013
2.2.2
Milling cutter
The milling cutter represented in
dence of the type of the gas nozzle.
Figure 2-2 Dimensions of the gas nozzle
Outside diameter gas nozzle
Outside diameter contact tube
Inside diameter gas nozzle
Distance of leading edge to nozzle stick
Contact tube
Contact tube
Contact tube
Distance of leading edge to contact tube
2-4
Figure 2-1
In principle, the TSC 2013 is delivered without milling
cutter. This must separately be ordered from ABB as a
spare part.
For the choice of a suitable milling cutter the measures
as well as the construction of the gas nozzle are
needed (see Figure 2-2).
Contact tube
Contact tube
flush
prodruding
The available values are to write down on the Dimen-
sion sheet Gas nozzle (see Chapter 5 Appendix) and
have to be transmitted to ABB Automation GmbH.
3HDA000057A8519-001
for removing welding spatters is selected into depen-
NOTICE
NOTICE
Contact tube
inwards
Ø X [mm]
Ø Y [mm]
Ø Z [mm]
A [mm]
prodruding
flush
inwards
B [mm]
NOTICE
Torch cleaner TC 2013
Advertisement
Table of Contents
