Wire Cutter; Designated Use; Technical Data - ABB TSC 2013 Assembly Instructions Manual

3

Wire cutter

The wire cutter is an option for the TC 2013 and can be retrofitted at any time. A wire cutter con-
version cut – Article No 3HDA000057A8405 is needed for this purpose.
Note: The wire cutter is already contained in the TSC 2013 (Torch Service Center).
Figure 3-1 TC 2013 with wire cutter
3.1

Designated use

The wire cutter is used for automatic cutting of the welding wire. It only works on combination with
a TC 2013, as it is actuated by the latter.
The wire cutter can be retrofitted on the TC 2013 at any time.
3.2

Technical data

Air pressure
Clamping cylinder - diameter
Stroke
Clamping force (at 5 bar)
Max. welding wire diameter for cutting
Weight
Supply data
Control voltage
Compressed air connection
Compressed air
Wire cutter
Wire cutter
3HDA000057A8519-001
5-10bar
45mm
36mm
790N
d= 1.0mm Steel
d= 1.2mm Aluminium
d= 1.2mm Steel
approx. 1.5kg
24V DC
G 3/8 inch
6 bar unoiled
Designated use
at minimum 5bar air pres-
sure
at minimum 6bar air pres-
sure
3-1