Arjohuntleigh Malibu Instructions For Use Manual page 33

Fig. 5
16 Soak a cloth in disinfectant.
17 Wipe all other contact areas such as the outside of the
bathtub (particularly behind the head), metal sensory knobs,
the hand control and the wheel chassis (optional) with the
cloth.
18 Wet a new cloth with water and remove all traces of
disinfectant on contact areas. The cloth should occasionally
be rinsed in running water when removing disinfectant.
Disinfect (Step 19-30 of 30)
19 Use a spray bottle and spray disinfectant in drain.
20 Close the drain.
21 Spray disinfectant on all internal bathtub surfaces, lift arm,
transfer chair and the loose parts and accessories at the
bottom of the bathtub. Turn accessories and spray on other
side. Pay attention to parts and knobs attached to the bathtub
surface such as drain control knob/surface overflow outlet.
(See Fig. 5)
22 Allow an appropriate contact time of the disinfectant
according to the instructions on the disinfectant bottle.
23 Open the drain.
24 Rinse all parts clean with plenty of water having a
temperature of approximately 25 °C (77 °F) using the
shower handle to remove disinfectant.
25 Soak a cloth in disinfectant.
26 Wipe all other contact areas such as the outside of the
bathtub (particularly behind the head), metal sensory knobs,
hand control and the wheel chassis (optional) with the cloth.
27 Allow an appropriate contact time of the disinfectant
according to the instructions on the disinfectant bottle.
28 Wet a new cloth with water and remove all traces of
disinfectant on contact areas. The cloth should occasionally
be rinsed in running water when removing disinfectant.
29 Leave to air dry.
30 Attach arm rests and seat. Make sure the seat is attached.
Attach the neck pillow, safety belt and rest of the
accessories.
33