Arjohuntleigh Malibu Instructions For Use Manual page 32

Fig. 1
1
2
Fig. 2
Fig. 3
Fig. 4
Clean and Disinfect with Spray Bottle
(30 Steps)
Remove visual residue (Step 1-7 of 30)
1 Raise bathtub to convenient working position.
2 Make sure all functions are turned off.
3 Open drain to empty any left over water.
4 Detach and place the loose parts such as armrests, seat of the
transfer chair, neck pillow and other accessories such as
safety belts on the bottom of the bathtub. (See Fig. 1)
5 Make sure the transfer chair is in the bathtub and not
outside.
6 Shower and rinse the bathtub, the lift arm and the transfer
chair with water to remove visible residue. Start from the
top and move downwards.
7 Shower and rinse the loose parts and the accessories in the
bottom of the bathtub with water to remove visible residue.
Turn accessories and loose parts and rinse again.
Clean (Step 8-18 of 30)
8 Put on protective gloves and eye wear. (See Fig. 2)
9 Spray/shower disinfectant in drain. Use a long handled
brush to scrub drain.
10 Close the drain.
11 Spray disinfectant on all internal bathtub surfaces, the lift
arm and the transfer chair and the loose parts and other
accessories at the bottom of the bathtub. Turn the loose parts
and the accessories and spray on other side. Pay attention to
parts and knobs and sensors attached to the bathtub surface
such as drain control knob/surface overflow outlet.
(See Fig. 3)
12 Spray into the surface overflow outlet. (See Fig. 3)
13 Scrub the surfaces of bathtub, the lift arm and the transfer
chair, loose parts and accessories with a soft bristle brush or
cloth (to remove any deposits e.g. skin flakes). Scrub
thoroughly, especially on handles and hand control.
(See Fig. 4)
14 Open the drain.
15 Rinse all parts clean with plenty of water having a
temperature of approximately 25 °C (77 °F) using the
shower handle to remove disinfectant.
32
Continue with the steps on the next page.