Preparing The Spalet ® Seat If Not Using For A Long Time - American Standard Advanced Clean 3.0 SpaLet User Manual

Preparing the SpaLet
Use the following procedure to drain the water and disconnect the power if the following circumstances are applicable.
● The SpaLet seat will not be used for an extended period of time due to travel. Not using the SpaLet for a long time
may cause water to become contaminated. This contaminant could deposit on the SpaLet seat.
● The SpaLet seat will not be used for an extended period of time due to being in a vacation home. As temperatures
drop in unoccupied houses during the course of seasons, water could freeze during times of cold temperatures.
Draining Water
n Close the water shut-off valve to shut off
1
the water supply.
* If the open/close knob is difficult to turn, grasp it
with a dry cloth and turn.
Turn clockwise
n Manipulate the flush lever in the Flush
2
Full direction to drain the water inside the
toilet tank.
n Drain the water from the water supply
3
side.
 Place a basin or similar beneath the strainer.
‚ Remove the strainer, rinse away dirt that has at-
tached to the strainer and O-ring, and then com-
pletely remove the part.
Flat-blade
screwdriver
Turn counterclockwise
[CAUTION]
● When removing the strainer, make sure not to dam-
age the water supply hose.
ƒ Insert the power plug into an outlet.
25 - EN
®
Seat if not using for a long time
Water shut-off
valve
Strainer
Water supply
socket
„ Press and hold both the [Massage] and
[Nozzle Cleaning] buttons for at least 2 seconds.
* Remaining water in the toilet body will drain over
a 15-second period.
[Massage] + [Nozzle Cleaning]
… Disconnect the power plug from the outlet.
† After the water has been drained, securely reattach
the strainer.
Tighten until the end surface
of the strainer is flush with
the socket end surface.
n Check for leaks from the water shut-off
4
valve.
■ Reusing the SpaLet seat
Always perform the necessary preparations and
checks before use. (
+
Turn clockwise
Page 7)