Operate The Spray - American Standard Advanced Clean 3.0 SpaLet User Manual

Preparation and Checks Before Use
STEP
3

Operate the Spray

1 Roll up your sleeve and set
n
your arm on the SpaLet
* The SpaLet seat is equipped with a seat sensor
that detects the presence of someone sitting on
the SpaLet seat.
The Spray and dryer will not function if the sensor
is not triggered.
* Allow the spray to operate for approximately 30
seconds to bleed air in the water line during initial
use.
2 Press the [Cleansing] button.
n
* At this time, water will discharge from around the
nozzle as a preliminary operation.
3 Place a hand above the noz-
n
zle tip to block the sprayed
water.
4 Press the [Stop] button to
n
stop the SpaLet.
9 - EN
®
seat.
Seat sensor switch
(Built into the seat unit)