American Standard Advanced Clean 3.0 SpaLet User Manual page 27

Draining the Water to Prevent Freezing
n Set the [Seat Temp.] to "High" and close
1
the seat lid (+ Page 10).
n Turn off any active power save function
2
(+ Page 18).
n Manipulate the water drain plug in your
3
building to drain water from the pipes.
* Do not close the water shut-off valve when manipu-
lating the water drain plug.
* Refer to the drain plug User Manual for more infor-
mation on the exact procedure.
n Move the flush lever to drain water from
4
the toilet tank.
n Drain water from the toilet body
5
n ,
3
* Refer to steps and
procedure on page 40 to drain the water from the
toilet bowl.
[CAUTION]
● ● When removing the strainer, be careful not to
damage the water supply hose.
 Press and hold the [Nozzle Cleaning] and [Massage]
simultaneously for at least 2 seconds.
* The water remaining in the seat unit drains out for
approximately 15 seconds.
‚ Raise the water supply hose attached to the seat
unit to drain water completely from the hose.
Seat unit water
supply hose
n After the water is drained, hold the water
6
supply socket with your hand, and tighten
the strainer firmly using the tool.
Tighten until the end surface
of the strainer is flush with
the socket end surface.
n ,
4
of the "Draining Water"
Turn clockwise
■ If water has frozen and the spray does not operate
If the water supply hose or water supply connec-
tions have frozen and the spray does not operate,
use a cloth immersed in warm water to warm the
water supply hose or water supply connections to
slowly thaw them, or warm the bathroom and allow
them to thaw naturally.
[CAUTION]
● Do not pour hot water or blow hot air over the water
supply hose.
* Doing so may result in damage to the water supply
hose.
● Water may be discharged during the thawing pro-
cess depending on the parts being warmed. Confirm
the condition regularly during the thawing process.
24 - EN