Front And Back Cleansing - American Standard Advanced Clean 3.0 SpaLet User Manual

General Operation
STEP
3

Front and Back Cleansing

Back Cleansing - Mild Oscillating Spray Super Oscillating Spray
Front Cleansing
1 Press the [Cleansing] button,
n
[Mild] , or [Bidet] button.
Back Cleansing functions wash any waste still remaining after a bowel movement.
Back Cleansing
Back Cleansing - mild
Front Cleansing functions wash any waste remaining during menstrual cycles or other circumstances.
Keep cleansing times between 10 to 20 seconds.
Back Cleansing/Back Cleansing - mild
(Press once)
The nozzle spray will
discharge from the nozzle
tip to wash your back
area.
Front Cleansing
(Press once)
The nozzle spray will discharge
from the nozzle tip to wash the
delicate areas of women.
3 Press the [Stop] button to
n
stop operation.
®
* This SpaLet seat is equipped with an auto-stop
function so that back cleansing and back cleansing
- mild operation stops automatically after 2 minutes.
Note that operation can be extended by an additional
2 minutes when other operations are performed while
cleansing operations are ongoing, such as the mas-
sage and oscillating spray functions, for a total of 6
minutes maximum of cleansing before automatically
stopping.
15 - EN
Wide Cleansing
: Sprays water to wash
: Sprays water with less pressure for a more gentle wash
Wide Cleansing
(Press twice)
The nozzle will move
back and forth to clean
over a wider range.
Wide Cleansing
(Press twice)
The nozzle will move
back and forth to clean
over a wider range.
n
Oscillating Spray - Super
Super oscillating Back Cleansing
(Press three times)
The nozzle will move back and forth
rapidly to wash more thoroughly.
* Press 4 times to cycle back to Back
Cleansing/Back Cleansing - mild.
Oscillating spray - super
(Press three times)
The nozzle will move back and forth
to clean over an even wider range.
* Press 4 times to cycle back
to Front Cleansing.
2 Press the [+] or [-] sides of
the Spray Strength button to
adjust the spray strength.
* There are 6 levels of spray strength available.
Start with a low setting and then gradually in-
crease the strength until the desired pressure is
reached.
* To increase pressure: Press the [+] side of the button.
To decrease pressure: Press the [-] side of the button.