If The Water In The Tank Is Frozen - American Standard Advanced Clean 3.0 SpaLet User Manual

If the Water in the Tank is Frozen

®
The water in the SpaLet
is significantly low.
Perform the following procedure to prevent freezing and related damage.
Do not disconnect the power plug from the outlet. Leave the power turned on. Turn off any active power save
function.
If the bathroom can be heated:
If the bathroom cannot be heated:
CAUTION
Make sure to follow one of the freezing prevention procedures whenever there is a
possibility of freezing.
* Damage from freezing may cause fire or flooding.
OBSERVE
General Freezing Prevention Procedure
n Set the [Seat Temp.] to "High" and close the seat lid
1
(+ Page 10).
n Turn off any active power save function (+ Page 18).
2
n Heat the bathroom.
3
Intermittent Nozzle Drain to Prevent Freezing
n Set the [Seat Temp.] to "High" and close the seat lid
1
(+ Page 10).
n Turn off any active power save function (+ Page 18).
2
n Press and hold both the [Massage] and [Nozzle
3
Position ] buttons for at least 2 seconds.
* Each pressing of these buttons will turn the function on and off.
* Flush the SpaLet seat every 6 minutes to prevent freezing.
Canceling Intermittent Nozzle Drain
Press the [Massage] and [Nozzle Position
same time for 2 seconds or longer.
* A beep will be heard on completion of the setting.
23 - EN
seat may freeze and cause damage during winter or other times when the water temperature
Refer to the "General Freezing Prevention Procedure" section.
Refer to the "Intermittent Nozzle Drain to Prevent Freezing" section or
"Draining the Water to Prevent Freezing" section.
[Massage] + [Nozzle Position
] buttons at the
[Seat Temp.]
]