American Standard Advanced Clean 3.0 SpaLet User Manual page 41

Installing the Nozzle Tips
* If the nozzle wand retracts, follow the steps
in the section, "Removing the Nozzle Tips," again to
extend the nozzle.
n Align the Detach mark on the right side of
1
the nozzle tip with the Center mark on the
nozzle wand, and then insert the nozzle
tip fully and turn it clockwise until it can
no longer be turned.
* Hold the nozzle at its base with your hand when
installing the nozzle tip.
②
Turn
clockwise
[CAUTION]
● ● There are two nozzles; one for back cleansing and
the other for front cleansing. Be sure to install the
nozzle tips to their nozzle wands.
● ● When installing the nozzle tip, make sure that the
hole on the nozzle tip is positioned at the top.
● ● Be careful not to damage the O-ring.
n n
and
2 3
O-ring
Center mark
①
Insert
Detach mark
Center mark
n Check the joint.
2
Center mark on
nozzle wand
Center mark on
nozzle tip
[CAUTION]
● ● After the installation, make sure that the Center
mark on the nozzle tip is aligned with the Center
mark on the nozzle wand.
* If the two Center marks are not aligned, a malfunction
may occur and the angle of the discharged water may
deviate from the proper position.
n Press the [Stop] button to retract the
3
nozzle.
[Stop]
Joint
38 - EN