Disassembling Product And Installing It At Another Location Such As When Moving; Disassembling Product And Installing; When Moving - American Standard Advanced Clean 3.0 SpaLet User Manual

Disassembling Product and Installing It at
Another Location Such as When Moving
Disconnecting the Water
Supply Hose
* Before disconnecting the water supply hose, close the
water shut-off valve and press the [Cleansing] button to
release internal pressure.
Remove the clip, and then disconnect the
water supply hose.
Gap
n Insert a flat-blade screwdriver into the gap.
1
Flat-blade screwdriver
n Push the tip of the screwdriver downward
2
toward the base of the box.
Flat-blade screwdriver
n With the screwdriver positioned in
3
the condition described in
screwdriver to disengage the claw.
Flat-blade screwdriver
* It becomes easier to disengage the claw if you twist
the screwdriver slightly while pushing.
● ■ Removing the product such as when moving to another house
When the product is removed and installed at another location such as
when moving, follow the procedure described below.
1. Remove the SpaLet
in the section, "Removing the seat unit" (+Page 32).
2. Push down the mounting plate. (+Page 33).
3. Remove the nuts located on the underside of the SpaLe seat unit.
* Do not lose the removed parts.
Lock section
* There is a
locking claw
inside.
n , push the
2
®
seat by following the procedure described
Connecting the Water Supply Hose
n Attach the water supply hose to the water
1
shut-off valve.
Water supply hose
n Attach the clip as shown in the illustrations
2
below. A clicking sound is produced when
the clip is attached properly.
* After the installation, turn the clip to ensure its firm
attachment. Also, pull the water supply hose lightly to
confirm secure connection.
Mounting bolt
Washer
Mounting bracket
Mounting plate
Bushing
Water shut-off valve
Fold
42 - EN