Reference Manual
00809-0100-5800
3. Connect the two 14 mm gas input and output line connectors at the flame arrestor.
4. Connect all cables and wiring connections as appropriate.
5. Remove the protective masking tape from the flanges, seal, and flamepath.
6. Close the enclosure as described in
7. Apply power to the analyzer.
Rosemount CT5800
Figure 7-36: Installing the Lower DIN Rail
Refer to
Replacing the gas input and output
CAUTION
PROTECT FLAMEPATH
Any damage to the flamepath will invalidate certification.
Use care not to damage the flamepath.
captive M16 bolts and engage the threads on the rear housing.
Troubleshooting and diagnostics
lines.
Closing the enclosure
and secure with the
September 2019
145