ATEX / IECEx Assessment Report Summary
September 2019
Table A-4: North America
Detail
Serial number
Year of manufacture
Warnings
Maximum supply pressure
A.9
Conditions of certification/special conditions
for safe use
•
This equipment has flamepaths which differ from those in IEC60079-1/EN 60079-1.
Cascade Technologies Ltd. shall be contacted for guidance when maintaining the
flamepaths.
•
The fasteners which secure the cover are non-standard and shall therefore only be
replaced by fasteners supplied by the manufacturer for this purpose. The fasteners
must always be fitted with the washer supplied by the manufacturer.
•
The equipment has non-conductive surfaces which are a potential electrostatic
charging hazard - see instructions for guidance.
•
The user shall ensure that the flow process gas is limited to a maximum flow rate of 6
liters per minute.
•
The equipment shall only be uses with process gases which are classified for equipment
group IIB + H2 and must not contain oxygen or any other oxidizer in concentrations
greater than those found in normal air.
North American conditions
•
The equipment has flameproof joints with dimensions which are other than those
specified in Table 2 of ANSI/UL 60079-1: 6th edition and Table 3 of CSA C22.2
60079-1:16. These flameproof joints are not intended to be repaired but where
necessary the original manufacturer shall be contacted for guidance and information
on the dimensions of the flameproof joints.
•
The fasteners which secure the cover are non-standard and shall therefore only be
replaced by fasteners supplied by the manufacturer for this purpose. The fasteners
must always be fitted with the washer supplied by the manufacturer.
•
The equipment has non-conductive surfaces which are a potential electrostatic
charging hazard - see the instructions for guidance.
174
(continued)
CSA North American Marking
As applicable
As applicable
WARNING - DO NOT OPEN WHEN AN EXPLOSIVE ATMOSPHERE IS
PRESENT.
WARNING - POTENTIAL ELECTROSTATIC CHARGING HAZARD - SEE
INSTRUCTIONS.
WARNING – DO NOT OPEN WHEN ENERGIZED.
WARNING – A SEAL SHALL BE INSTALLED WITHIN 50 mm OF THE
ENCLOSURE.
1 Bar
Reference Manual
00809-0100-5800
Emerson.com/Rosemount