Pyronix ENFORCER Series Programming Manual page 42

Fault Description
Case Tamper Case tamper switch open
XXX
Fault Description
Control End Station unable to
Panel communicate with Digi
Modem Fault Modem
Control Call to ARC from Digi
Panel ARC Modem Digi Modem has
Call Fail failed. Note: This is a
communication problem,
which is rarely caused by
an equipment fault.
Control PSTN Line Fault signalled
Panel Line by Digi Modem.
Fault 100
Enforcer: Programming Manual
DETECTION FAULTS
Solution
Secure switch closed. Same method of showing the
device as battery fault.
COMMUNICATION FAULTS
Solution
If modem not present, ensure that "Disable Digi" option
is set to 'YES' and "DOWNLOAD MODE" is set to 'NONE'
or 'RS232'. If present, but not detected, check the
modem is inserted correctly.
Check ALL call details are programmed correctly.
Ensure signalling format is correctly set for ARC
receiver. Ensure that calls to the ARC or SMS bureaux
numbers are allowed on the PSTN line, eg 0800, 0845
etc.
Only operative if "DOWNLOAD BY MODEM" selected OR
"DISABLE DIGI/SMS" is set to 'NO'
Note: 'Line Fault' timer operative.
Page: 42