Setting The Auto Arm Time; Allowing The Installer To Service Your System Remotely - Dls; User Callup; Late To Open - Johnson Controls Tyco PowerSeries Pro User Manual

Chapter
8

8.4 Setting the Auto Arm Time

The system can be configured to auto arm at a specific time on each day of the week. If a specific time is
not configured for a day of the week the system will not arm automatically on that day.
NOTE: This feature must be configured by installer.
To Set the Auto Arm Time
1. From the User Function menu use the shortcut key [0][3] or press [<]
[>] to scroll to Auto Arm Time.
2. Press [*] to open the days of the week sub menu. Scroll through the
days of the week and press [*] to set the time for that day.
3. Using a 24-hour format, set the desired time. After you enter the
fourth digit the screen will revert back to the previous day of the
week menu. Entering the time 9999 disables the Late-to-Open fea-
ture for that day.
4. Continue setting the time for the desired days of the week. When fin-
ished press [#] to return to the Ready state.
NOTE: If you set an invalid time the error tone will sound.

8.5 Allowing the Installer to Service your System Remotely - DLS

Occasionally, your installer may need to remotely access the Installer programming of your security sys-
tem using Downloading Software (DLS). In order for this to successfully occur, you may need to manually
allow access to your system.
NOTE: Access to this feature must be configured by installer.
To enable/disable System Service/DLS
1. From the User Function menu use the shortcut key [05] or press[<][>]
to scroll to SystemServ/DLS.
2. Press [*] to enable/disable the SystemServ/DLS feature.
3. When finished press [#] to return to the Ready state.

8.6 User Callup

Using DLS, User Call-up allows your system to make one attempt to connect to the installer's remote com-
puter. For a successful connection, the remote computer must be waiting for the system's call.
NOTE: Access to this feature must be configured by installer.
To perform a User Callup
1. From the User Function menu use the shortcut key [0][6] or press [<]
[>] to scroll to User Callup.
2. When finished press [#] to return to the Ready state.

8.7 Late to Open

The Late to Open feature provides notification if the alarm system is not disarmed by the programmed
time of day.
NOTE: Access to this feature must be configured by installer.
To enable/disable Late to Open
1. From the User Function menu use the shortcut key [0][9] or press [<]
[>] to scroll to Late to Open.
2. Press [*] to enable/disable the Late to Open feature.
3. When finished press [*] to return to the Ready state.
- -
25
LCD Display
Press (*) for <>
Auto Arm Time
Press (*) for <>
Sunday
Set 24Hr Time
Enter HH:MM 9999
Set 24Hr Time
Enter HH:MM 9999
LCD Display
Press (*) for <>
SystemServ/DLS
SystemServ/DLS
is Enabled
or
SystemServ/DLS
is Disabled
LCD Display
Press (*) for <>
User Callup
LCD Display
Press (*) for <>
Late to Open
Late to Open
is Enabled
or
Late to Open
is Disabled