Disarming The System; Disarming Error - Johnson Controls Tyco PowerSeries Pro User Manual

Chapter
4
3. Follow the Away arming procedure again, making sure to close the entry/exit door properly. For
more details see: "Away Arming the System with the Keypad".

4.12 Disarming the System

Depending on your system configuration, there are multiple methods you can use to disarm your system.
You can disarm the system using a keypad, 2-way wireless key or a proximity tag:
To Disarm the System with a Keypad
1. Enter your access code or present your proximity tag when the system is armed (Armed indicator is
on).
2. If you walk through the entry door, the keypad will beep. Disarm within _____ seconds to avoid an
alarm condition.
To Disarm the System with a 2-way Wireless Key
1. Press the disarm button when the system is armed (Armed
2. If you walk through the entry door the keypad will beep. Press the disarm button within ____
seconds to avoid an alarm condition.
NOTE: After disarming a system with an HS2LCD keypad using a 2-way wireless key, always check the
alarm memory to determine if any alarms have occurred during the armed period.
To Disarm the System with a Proximity Tag
1. Present your proximity tag to a keypad equipped with a proximity sensor when the system is armed
(Armed indicator is on) and if configured as required, enter your access code.
2. If you walk through the entry door the keypad will start beeping. Present your proximity tag within _
____ seconds to avoid an alarm condition.
NOTE: The Duration of Entry timer is programmed by your installer. The installer will advise the duration
of the entry delay programmed (valid entries are 30 seconds to 4 minutes). For SIA CP-01 classified
installations the entry delay must not exceed 45 seconds.

4.12.1 Disarming Error

If your code is invalid, the system does not disarm and a 2-second error tone sounds. If this occurs, press
[#] and re-enter your access code.
indicator is on).
- -
16