Step 05 - Sounders; Steps 06 To 09 - Remote Transmission - Siemens XC10 Series Installation, Commissioning Maintenance

12.4

Step 05 - Sounders

Description
Step
Option
05 Sounders: program the pattern
Fire alarm
01 Continuous
02 Pulsated slow
03 Pulsated fast
04 Pulsated slow
05 Continuous
06 Continuous
07 Pulsated slow
08 Not activated
09 Pulsated long
10 Pulsated fast
11 Pulsating fast
Pulsated fast = Active 1 second / Inactive 1 second
Pulsated slow = Active 1 second / Inactive 4 seconds
Pulsated long = Active 4 seconds / Inactive 1 second
Note: according to EN 12094-1 paragraph 4.30.2, sounders activation during released condition shall be continuous
12.5

Steps 06 to 09 - Remote transmission

Description
Step
Option
06 RT-alarm: program the activation
01 Active in state fire alarm
02 Active in state fire alarm, activated, released
03 Active in state activated, released
04 Active in state released
05 Active in state fire alarm, activated, released, zone 4 in alarm condition
Application: transmit RT-Alarm as soon as the DM1103-L is activated, even if "Manual blocked" is selected
07
RT-fault : program the activation
01 Activation : without delay on any fault
Duration : until buzzer silence
02 Activation : without delay on any fault
Duration : until buzzer silence and fault elimination
03 Activation : after 3 mn, on any fault, if buzzer is not silenced
Duration : until buzzer silence
04 Activation : after 3 mn, on any fault, if buzzer is not silenced
Duration : until buzzer silence and fault elimination
05 Activation : without delay on any fault, disable, mechanical blocking, loss of agent, incorrect status
Duration : until activation cause disappears
08 « Remote transmission » LED (9): activation and operation
01 Lights up on RT-alarm (Enable/Disable, via key 11, possible)
02 Lights up on RT-alarm and RT-fault (Enable/Disable, via key 11, possible)
03 Unused (key 11 disabled)
Application: Remote transmission not used [FR]
09 RT-Alarm and RT-Fault suppression when operating access level 2
01 Remote transmission not blocked
02 Remote transmission blocked
Application: avoid the remote transmission when the system is controlled by the operator
Building Technologies
Fire Safety & Security Products
Activated
Pulsated fast
Pulsated fast
Pulsated long
Continuous
Continuous
Continuous
Continuous
Continuous
Pulsated fast
Continuous
Continuous
outputs programmed as " Remote transmission" cannot be disabled
Emergency hold/abort
Pulsated slow
Pulsated slow
Pulsated fast
Pulsated slow
Pulsated slow
Continuous
Continuous
Pulsated slow
Pulsated slow
Continuous
Pulsating fast
Programming
Released
Pulsated fast
Continuous
Continuous
Continuous
Pulsated fast
Continuous
Continuous
Continuous
Continuous
Continuous
Continuous
53
A6V10257473_b_en_--.doc
01.2010