To Clean The Monitoring System - Covidien Nellcor PM100N Home Use Manual

To Clean the Monitoring System

Use any of the following to clean the monitoring
system:
• A soft cloth dampened with tap water, isopropyl
alcohol, or a 10% bleach solution (ask your clinician)
• A pre-moistened wipe (ask your clinician)
1. Remove the sensor from the patient and turn off
the monitoring system.
2. Dampen a soft cloth with tap water, isopropyl
alcohol, or a 10% bleach solution. If you are not
sure how to make the solution, ask your clinician. If
the cloth becomes soaked with liquid, start again
with a dry cloth.
Or, use a pre-moistened wipe recommended by
your clinician.
Support 1.800.635.5267
3. Gently wipe all surfaces of the monitoring system.
4. Allow the monitoring system to dry.
WARNING - Do not spray, pour, or spill any liquid on
the monitoring system, its accessories, connectors,
switches, or openings in the chassis, since this may
cause damage to the monitoring system.
41
PM100N Home Use Guide