Emerson Rosemount 3051S Quick Start Manual page 2

Quick Start Guide
Safety messages
NOTICE
This guide provides basic guidelines for the Rosemount
Transmitter (3051SHP). It does not provide instructions for diagnostics, maintenance, service,
troubleshooting, Explosion-proof, Flameproof, or intrinsically safe (I.S.) installations. Refer to the
Rosemount 3051SHP
electronically on Emerson.com/Rosemount.
Shipping considerations for wireless products.
The unit was shipped to you without the power module installed. Remove the power module prior to
shipping.
Each power module contains two "C" size primary lithium batteries. Primary lithium batteries are
regulated in transportation by the U. S. Department of Transportation, and are also covered by IATA
(International Air Transport Association), ICAO (International Civil Aviation Organization), and ARD
(European Ground Transportation of Dangerous Goods). It is the responsibility of the shipper to ensure
compliance with these or any other local requirements. Consult current regulations and requirements
before shipping.
WARNING
Explosions could result in death or serious injury.
Installation of this transmitter in an explosive environment must be in accordance with the appropriate
local, national, and international standards, codes, and practices. Review the approvals section of this
manual for any restrictions associated with a safe installation.
• Before connecting a handheld communicator in an explosive atmosphere, make sure the
instruments in the loop are installed in accordance with intrinsically safe or non-incendive field
wiring practices.
• In an explosion-proof/flameproof installation, do not remove the transmitter covers when power
is applied to the unit.
Process leaks could result in death or serious injury.
• To avoid process leaks, ensure secure connection with coned-and-threaded connection.
• Install and tighten process connectors before applying pressure.
Power module considerations.
• The power module may be replaced in a hazardous area. The power module has surface resistivity
greater than one gigaohm and must be properly installed in the wireless device enclosure. Care
must be taken during transportation to and from the point of installation to prevent electrostatic
charge build-up.
• This device complies with Part 15 of the FCC Rules. Operation is subject to the following
conditions:
— This device may not cause harmful interference.
— This device must accept any interference received, including interference that may cause
undesired operation.
— This device must be installed to ensure a minimum antenna separation distance of 20 cm
from all persons.
• Avoid contact with the leads and terminals. High voltage that may be present on leads can cause
electrical shock.
2
Reference Manual for more information. This document is also available
™
3051S High Static Differential Pressure
February 2019
Rosemount 3051SHP