Panasonic Lumix S1H Operating Instructions Manual page 49

You can set the way to record to card slots 1 and 2:
0
[ ] [
Card Access Indications
The card access light turns on while the
card is being accessed.
Removing a Card
1
Open the card door.
Check that the card access light A is
0
turned off and then open the card door.
2 Push the card until it clicks and then
pull the card out straight.
The card may be warm just after the camera has been used. Be careful when
0
removing.
Do not perform the following operations during access.
0
The camera may operate incorrectly or the card and recorded images
may be damaged.
– Turn off the camera.
– Remove the battery or card or disconnect the power plug.
– Subject the camera to vibration, impacts, or static electricity.
You can set so that the card access light does not turn on:
0
[ ] [
] [Double Card Slot Function] (l 92)
] [Card Access Light] (l 452)
2. Getting Started
49