Synchronise The Time Code Of The Camera With That Of The External Device (Tc In) - Panasonic Lumix S1H Operating Instructions Manual

Synchronise the Time Code of the Camera with That
of the External Device (TC IN)
The initial time code value of the camera is synchronised according to the
time code signal (LTC signal) of the external device.
In advance, change the [System Frequency] (l 253), [Rec Quality] (l 255),
0
and [Time Code Mode] (l 269) to match the external device.
1
Prepare for time code synchronising. (l 270)
2
Set [TC Synchronization] to
[TC IN].
[
≥
[External TC Setting]
Synchronization]
3
Operate the external device to
output the time code signal.
≥Set the time code count method of the external device to free run,
and output the signal.
≥When synchronised with the time code of an external device, this
camera is in a slave state, and the [
on the screen switches to [
When multiple units of this camera
0
are synchronised, the time code and
exposure timings are synchronised
so you can match the timings for
starting exposure between cameras.
The exposure timing can only be
0
synchronised the first time after [TC
Synchronization] is set to [TC IN].
] [ ] [Time Code]
[TC
[TC IN]
] of the time code shown
].
10. Recording Videos
273